Case Study

COOK CLEAN® with Solid Ring Technology Controls Emissions, Lasts Longer

Greenhouse Gas (GHG) reporting requirements highlight the need to reduce gas leakage at the point where most of it occurs – reciprocating compressor packing cases. A Gulf Coast energy company took the initiative to control this leakage from six of their compressors in natural gas transmission service.

The company’s Ariel JGT single-stage machines have suction pressures of 800 psig and discharge pressures of 1200 psig. Static vent leakage rates from the cylinders measured from 0.8 scfm up to 2.1 scfm. The company wanted to replace their conventional ring sets with zero emission/low leak packing.


After reviewing available options, the company chose a COOK CLEAN sealing system with solid ring technology. Solid Ring technology replaces conventional segmented back-up rings with uncut rings. These uncut rings eliminate leak paths to seal more effectively, especially at higher pressures.

Cook Solid Ring technology allows packing assemblies to run cooler, which reduces wear, extends run times and decreases maintenance costs. Each ring set includes multiple seal rings that load and unload sequentially based on pressure. This reduces friction by minimizing the number of rings in contact with the rod at any time. The increased sealing capacity of each ring set also allows fewer cups (and rings) to be used. The first ring set does most of the sealing, reducing the pressure applied to subsequent rings. As a result, the overall frictional heat load is greatly reduced.

COOK CLEAN sealing systems were installed in a total of 24 cylinders.


After installing COOK CLEAN systems with Solid Ring technology, vent leakage was reduced to near zero scfm. The same results were seen after 8,000 hours of operation. Even after 12,000 hours, measurements were from 0.0 scfm to 0.3 scfm across the 24 cylinders.

Related Case Study

California Gas Producer Hits Emissions Target with COOK CLEAN Sealing Systems

A Southern production/gas gathering/sales company was required to reduce cylinder emissions on 90% of their reciprocating gas compressors. COOK CLEAN sealing systems achieved the target and improved machine reliability 200-300%.

Read the Case Study >

Related Products & Services

Gas processing plant

Emissions Management

Emissions often originate from multiple sources, and several measures may be needed to achieve the desired level of control. Cook Compression can provide a full system assessment and consult with operators on options to meet objectives.
Cook Clean Packing Case

COOK CLEAN Packing Cases

COOK CLEAN systems provide a range of design options to prevent emissions from escaping to the atmosphere, including an advanced purge seal and a shutdown seal to control leakage when the compressor is on standby.
Packing case repair at Ellesmere Port facility

Packing Case Repairs

Cook Compression repairs all types of packing cases and sealing components, helping operators improve efficiency and reduce fugitive emissions.